![]() ![]() All printers that uses a Flashforge CoreBoard (all Rev.) powered by ARM Cortex-M4, STM32F407.Has been added in Repetier Server as 'Supported firmware' and all Druid parameters are auto-detected by Repetier Server.Extended Configurations and Capabilities report (M115, M360, M503), to improve auto-detection by all HOST (Octoprint, Repetier, etc).Compatible with almost all Host applications, but can also perform hostless printing.Robust password protection, preventing unauthorized use of the printer.Shorter data transmission to the host when reporting temperature, position, etc., allowing higher refresh rate.On screen 3D preview of the model and data using custom 3D implementation.GUI provides assisted procedures for many functions like: PID Tuning, Filament change, Manual Bed levelling.Currently supports only Cartesian, with planned development for CORE XY in 2023.Gcodes can be entered directly in the GUI using on-screen keypad.Support for Accelerometer, BL-Touch, expansion board.(Variable extruder cooling with parmeters PWM vs.TEMP) Extruder cooling fan controlled using preset graph.High Max Stepping rate, over 480Khz, when running on Flashforge Coreboard with 5 steppers.Uses less than 512 Bytes for all settings. Highly compressed persistent storage (EEPROM or Flash memory).GUI fully customizable, color, fonts, buttons, brightness, contrast, etc.GUI is running on the MCU and is an indissociable part of the firmware.SD card reader with a GUI file browser using touchscreen gestures. ![]()
0 Comments
Leave a Reply. |